Have you ever tuned your guitar and then played some notes high up on the neck just to find that they did not sound like they were in tune. If these two strings are intonated, the other strings will be close enough for most players. Correct saddle intonation with The Intonator, Learn About Guitar Bridge and Tailpiece Installation and Repair, Find the proper fret position with the official Stewart-MacDonald Fret Calculator, Stewart-MacDonald is PCI compliant and validated for secure e-commerce, Draw the front and back edge of the intended slot on the bridge (or use masking tape to indicate the slot location) and cut a straight saddle slot which offers the best average intonation for all the strings, especially the treble E and the A string. Hope you found this article interesting, and I’ll see you on the next post. have adjustments built in to fine tune their intonation. If the fretted notes are sharp, the string needs to be lengthened slightly. be adjusted, the proper strings should be on the guitar, and the string height should already be set. You can install "split saddles" if you are not working on a vintage instrument. All the saddles should point in the same direction. This lets you approximate any saddle radius, flat or arched, and any saddle height. This "traditional" saddle slot should be from 3/32" to 1/8" wide (Photo 9). Think of it as how in-tune the fretted notes sound in relation to the open strings. Remember that sharing is caring!! This will keep string kinks behind the saddle and prevent them from causing incorrect intonation (Photo 5). •   No matter how many orders you place. Usually two saddles are used, one short section for the treble-E and B strings, and the other section for the G, D, A and E strings. By using the L-saddles without the sleeves, or with any number of the three telescoping sleeves, four different saddle height options are available. As the truss rod bows the neck forward or back, it moves the nut. This is rarely the case in the real world. Photo 3 The adjustment screw should be at the front or back of the saddle. If it is, great! Cut the slot, install the mid-width saddle, and use the block of wood from Step 10 to help transfer your intonation measurements to the flat top of the saddle blank. But if it’s enough to warrant a truss rod adjustment, you’ll probably have to reset your intonation as well. Think of it as how in-tune the fretted notes sound in relation to the open strings. The Intonator finds the correct locations for acoustic flattop guitar bridge saddle placement. (Six individual saddles could be installed, although the tone of the instrument might be altered. ). There are cords to strum, riffs to chug on, and scorching leads to practice!! Tune the guitar. FREE Shipping with StewMAX is now available! Draw the front and back edge of the intended slot on the bridge (or use masking tape to indicate the slot location) and cut a straight saddle slot which offers the best average intonation for all the strings, especially the treble E and the A string. You’ll only need a few basic tools to do the job: a screwdriver, flat- or cross-head, depending on your guitar; the necessary tools to set string height, such as an Allen key; and a sensitive guitar … The following are four ways to proceed in making the permanent saddle: We use cookies on our website to make sure you get the best experience. A guitar with good intonation will sound in-tune anywhere along the neck. It’s a good idea to check intonation every month or two, or whenever you alter your setup in anyway. Let’s start out with the high E string. Remember, if the note at the 12th fret was sharp, move the saddle away from the neck. 4. But wait…..somethings wrong. Just inspect your guitar to see how to adjust the bridge saddles forward and backwards. they wouldn't let me 'watch' what they did, but I can tell the pups were lowered, the truss rob was adjusted, the action was lowered and they re-balanced the saddle… Save on Over 900 Items. Fret the low E-string at the 12th fret. The truss rod should already be adjusted, the proper strings should be on the guitar, and the string height should already be set. This is probably because the intonation on your guitar was a little bit off. 4. turn the screw to move the saddle. Direct: 1-604-855-7605 This is a starting reference line to aid in locating the saddle. Also be sure to grab your free copy of the Guitar Buyers Guide below!! This requires two separate saddle slots, of course, and the Intonator helps you accurately calculate their positions. 11. While the strings are at low tension, turn the thumbscrews to adjust all the saddles behind your penciled reference line. fret. When all the strings are correctly intonated, pencil the position of the front and back edges of each saddle on the top of the bridge. of the saddle. Be sure to lay cloth or thin piece of cardboard on top of the guitar as you’re working on it. Adjust each L-saddle so that the fretted note at the 12th fret matches the tuner when set one octave above the open note. will cause more neck relief and a higher string action. As you move the L-saddle, you must retune the string to the electronic tuner—keep the open string in tune as you continue moving the L-saddle, and match the 12th fret note to the tuner. to strum, riffs to chug on, and scorching leads to practice!! We recommend using the Intonator with an electronic tuner for optimum results. Re-tune the string and test the intonation of the fretted note again. If these two strings are intonated, the other strings will be close enough for most players. This will keep string kinks behind the saddle and prevent them from causing incorrect intonation (Photo 5). Look straight down from overhead and mark perpendicular to the bridge top (Photo 6). Some factors that can affect intonation include……. Most electric guitar and bass bridges have string saddles that are adjustable for intonation. The bridge is one of the most important parts for your guitars intonation. So why does intonation matter to you as a player? Some factors that can affect intonation include……, is one of the most important parts for your guitars intonation. guitarist and bass player should know how to do. 6. to complete. If your guitar plays in tune all the way up the fretboard, your audience will appreciate it and you will sound more like a professional guitar player. Adjusting the intonation is something that should be done at the end of a setup. 1. The adjustment screw should be at the. Note: adjusting the intonation of an acoustic guitar usually requires careful filing of the saddle and is best left to professional guitar techs. the process until the string is intonated. After you adjust the saddle accordingly, tune the string back up. - Nate Savage, 107-31265 Wheel Ave. A good tuner and a screwdriver are generally all that you need. A number of factors can affect your guitars intonation. We will be focusing on electric guitars and basses. Only give the screw 1-2 turns to start. 11. Install the remaining strings with only enough tension to hold the saddles. 5. Setting the intonation on a guitar basically involves moving the saddles forward or backwards until all of the notes all of the way up the fret board play as in tune as possible. How to Set Your Guitar's Intonation. Intonation should be the last thing you set. Also, a higher string action will have a greater affect on intonation then a lower action. This means that the saddles can be moved forward or backwards to change the string length slightly. 10. Test the screw to see which way moves the saddle forward or … Players with a heavy fretting hand and a strong grip tend to go, when they play. Toll Free: 1-800-439-8921 Setting intonation on a guitar or bass is something that any player can learn how to do. Layout a slot that has room for all the intonation points ( Photo 10 ) and file individual peaks as above. If your guitar looks different from the one in this video, don’t let that throw you off. So why does intonation matter to you as a player? If the note at the 12th fret is sharp or flat, the saddle will have to be adjusted to compensate for it. There are a lot of different kinds of guitars out there with different types of bridges. Set the Intonator in place on the bridge with L-saddles under those two strings. The peak of each L-saddle is halfway between the two marks, and this point should be the peak of the permanent saddle. Remember, if the note at the 12. the neck. The improved version of the classic Fender Strat Bridge, The most consistent, top quality Strat® replacement body on the market today. As the truss rod bows the neck forward or back, it moves the nut closer or farther from the bridge slightly. It can be a little tedious, but it’s easy once you know how. 9. 5. If the note was flat, move the saddle towards the neck. 6. File forward or backward to create slanted peaks for this partially-compensated saddle. Re: saddle all the way forward, intonation still off flat I took it to a luthier yesterday - for $40 they did a great job and completely reset everything.